Adil, логи с компорта нужны, возможно у вас проблема связанная с чет-то другим
Привет, munche! Выкладываю лог.
Board: STx7105-PDK [32-bit mode]19:192.168.3.1:255.255.0.0:Spark:
U-Boot 1.3.1-g72483220 (Jan 17 2012 - 17:10:49) - stm23_0051 - YW_1.1.003-9-g724
maceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=7000 nwhwconf=devi
8322 overclock
DRAM: 256 MiB
NAND: Bad block table found at page 262080, version 0x01ufacture=Spark-Project STB_ID=0C:00:0B:00:00:01:7E - 0
Bad block table found at page 262016, version 0x01
x0153d000 - 2897250 ...
512 MiB
SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
warning: SPI device may be write-protected (status=0x9c)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 0b 00 00 01 7e
Hit ESC to stop autoboot:
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867346 Bytes = 5.6 MiB
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970083 Bytes = 2.8 MiB
Image 1: 2897250 Bytes = 2.8 MiB
## Booting image at 80000000 ...
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867346 Bytes = 5.6 M
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970083 Bytes = 2.8 MiB
Image 1: 2897250 Bytes = 2.8 MiB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
stmac_phy_get_addr(): id1 = 0xffff, id2 = 0xffff
found phy at addres = 2
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = c0b0017e
Loading Ramdisk to 81d3c000, length 002c3562 ... OK
Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 root=/dev/ram0 init=/
linuxrc ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255.0.0:Spark:eth0:off stm
maceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=7000 nwhwconf=device:eth0,hw
addr:30:00:0B:00:01:7E Manufacture=Spark-Project STB_ID=0C:00:0B:00:00:01:7E - 0
x0153d000 - 2897250 ...
