Только что прошил ресивер как указанно в первом посте вот тут
https://giclub.tv/index.php/topic,1404.0.html Вот лог HyperTerminalWarning: MAC addresses don't match:
HW MAC address: FF:FF:FF:FF:FF:FF
"ethaddr" value: 00:80:E1:12:06:38
Using MAC Address 00:80:E1:12:06:38
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
STM-GMAC: 100Mbs full duplex link detected
TFTP from server 192.168.0.2; our IP address is 192.168.0.63
Filename 'mImage'.
Load address: 0x80000000
Loading: #############(много диезов)
done
Bytes transferred = 5867410 (598792 hex)
Un-Protect Flash Bank # 1
................................................................................
....................................................... done
................................................................................
................................ done
Erased 112 sectors
Copy to Flash... ...............................................................
................................................................................
................................................................................
................................................................................
.......................................................done
** Can't read from device 0 **
** Unable to use usb 0:1 for fatload **
Warning: MAC addresses don't match:
HW MAC address: FF:FF:FF:FF:FF:FF
"ethaddr" value: 00:80:E1:12:06:38
Using MAC Address 00:80:E1:12:06:38
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
STM-GMAC: 100Mbs full duplex link detected
TFTP from server 192.168.0.2; our IP address is 192.168.0.63
Filename 'userfsub.img'.
Load address: 0x80000000
Loading: #################
32 MiB received
#################
64 MiB received
#################
96 MiB received
################# (во всех строчках диезов оч.много)
done
Bytes transferred = 122388288 (74b7f40 hex)
NAND erase: device 0 offset 0x800000, size 0x17800000
Skipping bad block at 0x06200000
Erasing at 0x17fe0000 -- 100% complete.
OK
NAND write: device 0 offset 0x800000, size 0x74b7f40
Bad block at 0x6200000 in erase block from 0x6200000 will be skipped
Writing data at 0x794e000 -- 100% complete.
122388288 bytes written: OK
Unprotecting Flash...
.. done
Un-Protected 2 sectors
Erasing Flash...
.. done
Erased 2 sectors
Writing to Flash...
........ done
Protecting Flash...
.. done
Protected 2 sectors
0
ЛОГ CISCO TFTP SERVERFri Jun 21 11:12:10 2013: Sending 'mImage' file to 192.168.0.63 in binary mode
Fri Jun 21 11:12:15 2013: Successful.
Fri Jun 21 11:14:43 2013: Sending 'userfsub.img' file to 192.168.0.63 in binary mode
Fri Jun 21 11:16:23 2013: Successful.
После тюнер перегрузился вот лог## Booting image at a0080000 ...
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867346 Bytes = 5.6 MiB
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970083 Bytes = 2.8 MiB
Image 1: 2897250 Bytes = 2.8 MiB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = 90b011462
Loading Ramdisk to 80d3c000, length 002c3562 ... OK
Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/d
ev/ram0 ip=192.168.0.69:192.168.0.119:192.168.0.1:255.255.255.0:lh:eth0:off stmm
aceth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwa
ddr:24:00:0B:01:14:62 Manufacture=Spark-Project STB_ID=09:00:0B:00:01:14:62 - 0x
0053d000 - 2897250 ...
[MAIN] init finish,errCode=0